That will let you assign a USB B input to a mixer input channel and you can then treat it as a mixer input source with full processing. To patch the USB B as a playback input you need to go the pre-amp input patch menu. My goal is to run the audio into my laptop and out via OBS Project for casting.Īre you wanting to play back audio from the computer into the mixer via the USB B connection? I suspect that something simple is being missed.

I plug the usb into my computer and get very little through that device, Line In (QU32). When assigning input channels to a group mix and assigning that group or groups to the main LR mix you need to go to those channels and un-assign them from the main LR mix outs.Ĭould I get a simple break down of what I need to set to get our QU32 to play correctly via USB-B out? I do have the drivers and DAW install on the pc for it to connect to. Mix balance the levels as needed, you can still add all of the needed output processing I would suggest applying some compression to the live stream feed.Īnother way would be to use the mix groups with a group for vocals, instruments and spoken word, assign those groups to the LR main mix and to the matrix, within the matrix If you use a mix set that mix to post fade, you can assign that mix directly to the USB out channels and have full over all control of levels, EQ, compression going to the live stream. Say you need to bring up the spoken word input channels to the live stream just raise those on that mix, same goes for instruments that may be acoustically louder in the room but are too low on the live stream mix. If your wanted to do some tweaks to the mix going to the live stream you could use a mix buss for that. Not sure how you are exactly routing the matrix but you can not send a DCA group to the matrix mix.

Laptop sound very low